mirror of
https://github.com/qmk/qmk_firmware.git
synced 2024-12-16 14:43:24 +00:00
05b479d349
* Add TADA68 keymap/rules/config for QMK bootloader * Remove extraneous #DEFINEs * use #pragma rather than include guards Co-Authored-By: fauxpark <fauxpark@gmail.com> * Remove obselete #endif Co-Authored-By: fauxpark <fauxpark@gmail.com> * #undefine DESCRIPTION before redefining Co-Authored-By: fauxpark <fauxpark@gmail.com> * Remove obselete #define Co-Authored-By: fauxpark <fauxpark@gmail.com> Co-authored-by: fauxpark <fauxpark@gmail.com>
35 lines
1.7 KiB
Markdown
35 lines
1.7 KiB
Markdown
# TADA68 (65% ATMega32U4 PCB)
|
|
|
|
The TADA68 comes with a custom firmware based on the LUFA mass storage
|
|
driver, which mounts the user-accessible portion of the flash storage
|
|
as a USB drive. This is prone to failure and can only be accessed by
|
|
hitting the physical reset button on the base of the board, which is
|
|
relatively accessible in an assembled keyboard.
|
|
|
|
This keymap has some customisation to work with a TADA68 which has been
|
|
ISP-reflashed (using a USBasp or other ISP) to work with the QMK bootloader.
|
|
|
|
This allows use of dfu-programmer to reflash the firmware in DFU mode, and
|
|
bootloader entry and exit with key-combos.
|
|
|
|
To build the firmware, set up a build environment according to the standard
|
|
QMK instructions, then run:
|
|
|
|
```make tada68:tokyovigilante:production```
|
|
|
|
which will build the bootloader, user firmware, and the combined image `<keyboard>_<keymap>_production.hex`.
|
|
|
|
Then run
|
|
|
|
```avrdude -F -c usbasp -p m32u4 -e -U flash:w:tada68_tokyovigilante_production.hex:a -U lfuse:w:0x5E:m -U hfuse:w:0xD9:m -U efuse:w:0xC3:m -U lock:w:0x3F:m```
|
|
|
|
to copy it to your board (connected to the USBasp or other programmer, replacing the -c and filename parameters as required). The fuse and lock
|
|
bitmaps will enable DFU mode.
|
|
|
|
Once the board is unplugged and plugged in via USB, the default key-combo to
|
|
enter DFU mode is Fn-Meta-R, then Esc to exit. You can then use
|
|
`make tada68:<keymap>:dfu` to build and flash any other custom keymap you
|
|
like, as the qmk-dfu bootloader can only be replaced using the ISP. This keymap is fairly basic, just make sure any replacement one has a RESET command defined (ideally on a non-default layer).
|
|
|
|
More information can be found in the QMK docs: <https://docs.qmk.fm>
|