mirror of
https://github.com/qmk/qmk_firmware.git
synced 2025-02-27 01:56:43 +00:00
29 lines
1.2 KiB
Markdown
29 lines
1.2 KiB
Markdown
# MacroPad 10 RP2040
|
|
|
|
A RP2040-powered Macropad with a 2x5 layout.
|
|
|
|
Make example for this board (after setting up your build environment):
|
|
|
|
```sh
|
|
qmk compile -kb handwired/set_st/rp2040 -km via
|
|
```
|
|
|
|
See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
|
|
|
|
## Features
|
|
|
|
- Raspberry Pi RP2040 Zero or Plus.
|
|
- 2x10 Mechanical key switch sockets - accepts any Cherry MX-compatible switches. Individually tied to GPIO pins (not matrix wired)
|
|
- One NeoPixel RGB LED per switch, on north side.
|
|
- Rotary encoder, 20 detents per rotation, with push-switch on GPIO pin.
|
|
- 128x64 SH1306 Monochrome OLED i2c display.
|
|
|
|
## Bootloader
|
|
|
|
Enter the bootloader in 4 ways:
|
|
|
|
* **Bootmagic reset**: Hold down the key just below the rotary encoder push-button on power-up.
|
|
* **Physical reset button**: Press twice the button on the side while the board is connected.
|
|
* **BOOT button** Hold down the rotary encoder push-button on power-up or reset.
|
|
* **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available.
|