qmk_firmware/keyboards/4pplet/perk60_iso/rev_a
2024-01-02 03:07:28 +00:00
..
config.h Migrate RGB Matrix config to info.json - [0-9] (#22797) 2024-01-02 03:07:28 +00:00
halconf.h [Keyboard] 4pplet Perk60 (#16853) 2022-07-23 13:23:14 -07:00
info.json Migrate RGB Matrix config to info.json - [0-9] (#22797) 2024-01-02 03:07:28 +00:00
mcuconf.h Migrate more F4x1 board files (#18046) 2022-08-15 00:25:40 +01:00
readme.md [Keyboard] 4pplet Perk60 (#16853) 2022-07-23 13:23:14 -07:00
rev_a.c Update keyboard LED driver configs (#22638) 2023-12-18 20:13:08 +00:00
rev_a.h Move single 60_ansi, 60_hhkb and 60_iso layouts to data driven (#20438) 2023-04-15 21:09:08 +10:00
rules.mk Remove CORTEX_ENABLE_WFI_IDLE from keyboards. (#21353) 2023-06-23 20:31:25 +01:00

Perk60 ISO Rev A

  • Keyboard Maintainer: 4pplet
  • Hardware Supported: Perk60 ISO Rev A

Make example for this keyboard (after setting up your build environment):

make 4pplet/perk60_iso/rev_a:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

How to enter bootloader (DFU):

  • Press and hold the button on the keyboard (the small one on the same side as the MCU) for more than 1 second. The keyboard will then enter bootloader (DFU) mode and it's ready to flash the firmware.
  • Note: If holding the button a shorter time, the keyboard will just reset. If you want to exit bootloader mode without flashing a firmware, dissconnect the keyboard from your PC and reconnect it.

Alternative option if the firmware is already pre-flashed:

  • Unplug your keyboard, hold down the Spacebar and B at the same time, plug in your keyboard and wait a second before releasing the keys. Bootmagic lite is enabled by default.