mirror of
https://github.com/qmk/qmk_firmware.git
synced 2024-12-12 12:51:18 +00:00
416af0171c
* Remove CORTEX_ENABLE_WFI_IDLE from the codebase. * Turn on CORTEX_ENABLE_WFI_IDLE by default. |
||
|---|---|---|
| .. | ||
| keymaps | ||
| chconf.h | ||
| config.h | ||
| halconf.h | ||
| info.json | ||
| matrix_diagram.md | ||
| mcuconf.h | ||
| readme.md | ||
| rev_a.c | ||
| rev_a.h | ||
| rules.mk | ||
Viper/Eagle REP Rev A
A alternative PCB for Viper and Eagle V2 and V3
- Keyboard Maintainer: 4pplet
- Hardware Supported: Viper/Eagle REP Rev A
Make example for this keyboard (after setting up your build environment):
make 4pplet/eagle_viper_rep/rev_a:default
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
How to enter bootloader (DFU):
- Press and hold the button on the keyboard (the small one on the same side as the MCU) for more than 1 second. The keyboard will then enter bootloader (DFU) mode and it's ready to flash the firmware.
- Note: If holding the button a shorter time, the keyboard will just reset. If you want to exit bootloader mode without flashing a firmware, dissconnect the keyboard from your PC and reconnect it.
Alternative option if the firmware is already pre-flashed:
- Unplug your keyboard, hold down the Spacebar and B at the same time, plug in your keyboard and wait a second before releasing the keys. Bootmagic lite is enabled by default.