mirror of
https://github.com/qmk/qmk_firmware.git
synced 2024-11-23 03:42:59 +00:00
6809f154c9
Co-authored-by: Drashna Jaelre <drashna@live.com> Co-authored-by: Joel Challis <git@zvecr.com>
36 lines
1.7 KiB
Markdown
36 lines
1.7 KiB
Markdown
# Handwired 87 keys
|
|
|
|
|
|
|
|
Repaired from 87 keys keyboard using a Pro Micro
|
|
|
|
* Keyboard Maintainer: [KD-MM2](https://github.com/KD-MM2)
|
|
* Hardware Supported: Pro Micro(need to solder more pins) or any board with ATMega32u4
|
|
* Hardware Availability: N/A (private board, might open source)
|
|
|
|
First, if you have Pro Micro
|
|
Checkout these image for more:  
|
|
Keymaps/Handwiring: 
|
|
If you have 25 GPIOs board, there is nothing to do.
|
|
|
|
Second, if you are using a Capslock LED, define LED pin in: [config.h#34](https://github.com/KD-MM2/qmk_firmware/blob/hwpm87/keyboards/hwpm87/config.h#L34),
|
|
and check the LED_PIN_ON_STATE if you get reversed led state: [config.h#35](https://github.com/KD-MM2/qmk_firmware/blob/hwpm87/keyboards/hwpm87/config.h#L35)
|
|
|
|
Make example for this keyboard (after setting up your build environment):
|
|
|
|
make handwired/hwpm87:default
|
|
|
|
Flashing example for this keyboard:
|
|
|
|
make handwired/hwpm87:default:flash
|
|
|
|
See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
|
|
|
|
## Bootloader
|
|
|
|
Enter the bootloader in 3 ways:
|
|
|
|
* **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
|
|
* **Physical reset button**: Plug cable, open QMK Toolbox and short RST pin and GND pin, then you will see it in flashmode
|
|
* **Keycode in layout**: Press the key mapped to `RESET` if it is available
|