mirror of
https://github.com/qmk/qmk_firmware.git
synced 2024-12-05 01:15:19 +00:00
7e0299117b
Co-authored-by: Nick Brassel <nick@tzarc.org> |
||
---|---|---|
.. | ||
keymaps/default | ||
config.h | ||
info.json | ||
readme.md | ||
rules.mk | ||
snatchpad.c | ||
snatchpad.h |
snatchpad
A 6-key macropad with 2 rotary encoders intended for use as a pointing device.
In addition to the 3d printed parts and microcontroller, the following hardware is required:
- 4 * 3x3 mm threaded inserts
- 4 * 4mm M3 bolt
- USB daughter board
Make example for this keyboard (after setting up your build environment):
make handwired/snatchpad:default
Flashing example for this keyboard:
make handwired/snatchpad:default:flash
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
Bootloader
Enter the bootloader in 3 ways:
- Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
- Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
- Keycode in layout: Press the key mapped to
QK_BOOT
if it is available