qmk_firmware/keyboards/tkw/grandiceps
2023-01-31 06:03:30 +11:00
..
keymaps/default Remove legacy keycodes, part 6 (#18740) 2022-10-16 14:14:40 +01:00
rev1 Move keyboard USB IDs and strings to data driven, pass 2: S-Y (#18093) 2022-08-20 01:48:38 +01:00
rev2 Move keyboard USB IDs and strings to data driven, pass 2: S-Y (#18093) 2022-08-20 01:48:38 +01:00
config.h Remove usages of config_common.h from config.h files. (#19714) 2023-01-31 06:03:30 +11:00
grandiceps.c Keyboard/grandiceps (#11933) 2021-03-15 17:42:09 +00:00
grandiceps.h Keyboard/grandiceps (#11933) 2021-03-15 17:42:09 +00:00
halconf.h Keyboard/grandiceps (#11933) 2021-03-15 17:42:09 +00:00
info.json Move keyboard USB IDs and strings to data driven, pass 2: S-Y (#18093) 2022-08-20 01:48:38 +01:00
mcuconf.h Keyboard/grandiceps (#11933) 2021-03-15 17:42:09 +00:00
readme.md RESET -> QK_BOOT keyboard readme (#18110) 2022-08-20 11:34:17 +01:00
rules.mk Move keyboard USB IDs and strings to data driven, pass 2: S-Y (#18093) 2022-08-20 01:48:38 +01:00

grandiceps

grandiceps

ARM split keyboard with RGB underglow and encoders.

  • Keyboard Maintainer: vattern
  • Hardware Supported: f411 blackpill
  • Hardware Availability: grandiceps

There are two versions of the Grandiceps. Please use the appropriate firmware for your board.

  • Revision 2 has I2C eeprom and support for a Pimoroni trackball.

Make example for this keyboard (after setting up your build environment):

make tkw/grandiceps:default
make tkw/grandiceps/rev2:default

Flashing example for this keyboard:

make tkw/grandiceps:default:flash
make tkw/grandiceps/rev2:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset buttons: Hold down the BOOT0 button and then briefly press the NRST button on the BlackPill PCB.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available