qmk_firmware/keyboards/handwired/3dfoxc
Ryan 5c592ab0c0
Delete trivial keymap readmes (#23714)
2024-05-17 23:49:29 +01:00
..
keymaps/default Delete trivial keymap readmes (#23714) 2024-05-17 23:49:29 +01:00
keyboard.json Migrate features from rules.mk to data driven - EFGH (#23248) 2024-03-15 01:42:55 +00:00
readme.md RESET -> QK_BOOT keyboard readme (#18110) 2022-08-20 11:34:17 +01:00

readme.md

3dfoxc

3dfoxc

A 3d-printed whitefox with an Elite-C microcontroller.

This is a build of matt3o's "How to Build a Custom Keyboard" guide, except that I have replaced the Teensy with an Elite-C v4. Presumably you could replace it with anything compatible. The USB-C port had to be enlarged with dremel, and the mount for the Teensy was ground off and replaced with everyone's favorite rapid modeling polymer ... hot glue.

Wiring

Badly, because I have never done this before. Build pics available upon request, I guess.

wiring diagram

Flashing

Make example for this keyboard (after setting up your build environment):

make handwired/3dfoxc:default

Flashing example for this keyboard (use the dfu target for the Elite-C!):

make handwired/3dfoxc:default:dfu

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available