/* * Copyright 2022 Charly Delay <charly@codesink.dev> (@0xcharly) * * This program is free software: you can redistribute it and/or modify * it under the terms of the GNU General Public License as published by * the Free Software Foundation, either version 2 of the License, or * (at your option) any later version. * * This program is distributed in the hope that it will be useful, * but WITHOUT ANY WARRANTY; without even the implied warranty of * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the * GNU General Public License for more details. * * You should have received a copy of the GNU General Public License * along with this program. If not, see <http://www.gnu.org/licenses/>. */ #pragma once /* Key matrix configuration. */ #define MATRIX_ROW_PINS \ { GP4, GP5, GP28, GP26 } #define MATRIX_COL_PINS \ { GP8, GP9, GP7, GP6, GP27 } /* Handedness. */ #define MASTER_RIGHT // To use the handedness pin, resistors need to be installed on the PCB. // If so, uncomment the following code, and undefine MASTER_RIGHT above. //#define SPLIT_HAND_PIN GP29 // If you've soldered the handedness pull-up on the upper side instead of the // left one, uncomment the following line. //#define SPLIT_HAND_PIN_LOW_IS_LEFT // High -> right, Low -> left. /* serial.c configuration (for split keyboard). */ #define SOFT_SERIAL_PIN GP1 /* CRC. */ #define CRC8_USE_TABLE #define CRC8_OPTIMIZE_SPEED /* Reset. */ #define RP2040_BOOTLOADER_DOUBLE_TAP_RESET #define RP2040_BOOTLOADER_DOUBLE_TAP_RESET_LED GP17 #define RP2040_BOOTLOADER_DOUBLE_TAP_RESET_TIMEOUT 1000U