mirror of
https://github.com/qmk/qmk_firmware.git
synced 2024-12-19 08:03:22 +00:00
27 lines
1.1 KiB
Markdown
27 lines
1.1 KiB
Markdown
|
Split Tester
|
||
|
|
============
|
||
|
|
|
||
|
|
A two-switch tester built using two Pro Micros, mainly intended to test RGB on split keyboards. Seen here: https://www.instagram.com/p/BvCPNzynwrV/
|
||
|
|
|
||
|
|
Keyboard Maintainer: [Bakingpy/nooges](https://github.com/nooges)
|
||
|
|
Hardware Supported: Pro Micro
|
||
|
|
|
||
|
|
Make example for this keyboard (after setting up your build environment):
|
||
|
|
|
||
|
|
make handwired/splittest:default
|
||
|
|
|
||
|
|
Example of flashing this keyboard:
|
||
|
|
|
||
|
|
make handwired/splittest:default:avrdude
|
||
|
|
|
||
|
|
See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
|
||
|
|
|
||
|
|
Wiring
|
||
|
|
------
|
||
|
|
- Add switches to both Pro Micros across B3 and B6 pins
|
||
|
|
- Add pull-up resistor to left side between VCC and F6
|
||
|
|
- Add pull-down resistors to right side between GND and F6
|
||
|
|
- Connect the following pins on both sides together: D0, D1, GND, VCC
|
||
|
|
- Add I2C 4.7kOhm resistors between D0 and VCC, and D1 and VCC
|
||
|
|
- Wire Di of RGB strip for each half to D2
|